Welcome back!

Cleaning your fish tank is task that must be done every few weeks or so until your tank is established. Once established, your tank will only need to be cleaned a few times a month. If you do clean your tank right the process can be very easy or difficult. The size of your tank can depend on how long it takes to clean. The bigger the tank and more decor is the, the harder it will be to clean.

When cleaning a tank, changing the filters is the first step. If you have a bio filter, or power filter changing the filters is a breeze. A under gravel filter is another story. You must remove all the plants, decor and accessories. Then you must pull it out from under the gravel to clean.

Once the filters are cleaned, replace them with new ones. If you have an underground filter do not replace it back in the tank yet. If you have an established tank then leave the plants and decor, even if they have algae on them. Black and smaller algae are vital for a healthy tank and should be left on the decor and accessories. If you do not have an established tank or smaller tank, (ten gallon or smaller) then wash off all the plants and decor. If you have real plants do not wash them. Washing live plants can damage or kill them; the best choice is to leave them in the tank.

After the accessories, decor and plants have been washed do not place them back in the tank yet. The next step is to siphon the tank. Siphon no more than one third of the water out of the tank. If there is still debris at the bottom of the tank fill it with water and re siphon until all debris is gone. If you have an established tank then only siphon out some of the debris and leave a little in the gravel.

When replacing the water only use soft water so the fish do not die of shock. Soft water is water without minerals. Tap water or filtered water is considered soft water. After the water has been replaced remember to not fill the tank too high because, the plants, decor and filters have to still be added.

Replace the under gravel filter if you have one. Then replace the plants and decor. You’re all done, and now your tank is clean. Remember that cleaning a tank can be traumatizing for the fish, so they might be timid for a while after the clean.

Roshan Goodman gives cool info on fish tank advice and advice on cleaning an aquarium .

A fuse is a single phase device that is employed in almost every electrical circuit for protecting them against overload conditions. It is basically the weakest point or link in a circuit that burns out before any other expensive electrical appliance. Thus, it acts as a safety device that checks for circuit overloading and overheating of wires.

The basic function of an electric fuse is to prevent healthy part of the circuit from being damaged and to limit the damage to the faulty sections or items to the lowest possible level.

The current is interrupted when the elements which carry the current are melted by the heat generated by the current. When a condition of overload arrives, fuse blows off. This confirms the replacement of a new fuse so as to further protect the devices from any damage.

Replacing a fuse is a pretty easy home maintenance task but you need to be very careful because electricity can be dangerous. Unplug all the devices that are connected to the power supply prior to fuse replacement. In addition to this, use a correct rating fuse every time you replace it.

Even if replacing a fuse is a very small job, there’s still a potential to danger and yo must use caution. We must always take remember to care and to follow some simple rules. Don’t go for replacing the fuse with wet hands. Make sure, your hands are not wet while doing the job. Secondly, replace the blown off fuse with a good one without touching the metal terminals or use proper tools like pliers and screwdriver etc.

If the fuse blows again before turning on any device, a serious wiring fault may exist. Call in a qualified electrician immediately.

Since, the fuse presents the most cost effective means for providing automatic high- voltage current protection against the single over current failure and so they are used in many electrical systems. Fuse is a very simple and highly reliable, low cost and compact device. Because of the above advantageous features, fuses have been and are used in wide variety of applications.

Nowadays, fuses are a nondetachable part of electrical systems in automobiles, boats, motor cycles and other vehicles. Additionally, these are now employed in integrated circuits to provide redundancy and programming capabilities.

Scott Rodgers is a great writer when it comes to extensive electrician works. His stupendous knowledge has been fueling business opportunities for a host of workers, ranging from Spring House Electricians (Need one? click here!) to Havertown Electricians (Need one? click here!).